in case of induction motor when overload condition or any
short ckt. why stator winding burn not to be rotor winding
- 2 Answers
- 3998 Views
- I also Faced
- E-Mail Answers
Answer Posted / sreenu
Because IM rotor is short circuited with copper bars, which
can carry more current rating than stator windings.
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
Explain the propagation of harmonics in the network and influence of phase angle of harmonics.
Why do we perform an open-circuit test and short-circuit test on the transformer?
What are the advantages of vscf wind electrical system?
How can two 3 phase transformers of same KVA and Voltage be connected in parallel?
what is the minimum voltage require to injure our body?
WHAT SHOULD BE THE BEST CURRENT RATINGS (PRIMARY / SECONDARY)FOR A CT INSTALLED AT THE INCOMING 11KV PANE? WILL IT BE CALCULATED ON THE BASES OF MAXIMUM DEMANT VALUE OR ON SUM OF ALL TRANSFORMER'S KVA? NOMALLY MAX DEMAND REPRESENT THE MAXIMUM OPERATING LOAD OF THE PLANT AND TOTAL KVA OF (SAY 5 NUMBERS TRANSFORMERS) REPRESENT THE CONNECTED LOAD. WHICH i.e. MAX DEMAND KVA OR CONNECTED KVA ARE BETTER TO USE FOR CT CURRENT CALCULATION? PLEASE ANSWER.
Explain Need of a starter in a dc motor.? Also explain any two starting and speed control method of dc motor?
is the value of inductance depends upon the value of thitha in doubly excited machine??
What is the simplest formula to calculate the rotor diameter of a synchronous generator?
please suggest some good universities with low cost iam in totally full confusion so please help me my profile gre 283 and ielts 5.5
What does the letter CTNM in negative phase sequence relay means?
please send me privious exam's queation papers of section engineer(electrical).
how is capacitor bank look like
what is the calculation method to design core and winding of a 200kva 3phase distribution transformer?
