1.Is there any difference between terminologies,HT-HV <-
LV?
2.What is the highest transmission voltage level in india?
Answer Posted / jk
HT-HV means HIGH TRANSMISSION-HIGH VOLTAGE (>1000V)
LT-LV means LOW TRANSMISSION-LOW VOLTAGE (<1000V)
The highest transmission voltage in India is 400KV
Is This Answer Correct ? | 10 Yes | 7 No |
Post New Answer View All Answers
why 15 kw motor winding resistance is low then 5 kw motor winding resistance?
what is the mechanical safety of DG ?
When calculation of fault current and fault Kva is to be done,why always we use per unit value and why we consider the base kva?
In dc ckt. 24v or 110v, which one is more efficient and why?
y we use neutral,all r told its used to for closed path..k its a just used to closed path,in a transmission line y we put same conductor used n both phase and neutral..if we use less than phase conductor in neutral mean we ll reduce cost its right r wrong..if we use mean any problem occur in transmission line..
What is the effect on in Zone and out zone fault if Phase side CT is Vk/2<30 mA and Neutral side is CT is Vk/4<30 mA for Transformer REF protection
how much GROUND & NEUTRAL VOLT maintain in data center.
What should be the amps for a MV fuses for transformer 630kVA 20(10)/0.4 kV
what is vtg limit of earth and neutral at transformer side?
how to failure indution motor insulation & how to improve heat in motor insulation
what is KSR type transmission tower? What is LSR type transmission tower?
What is boucholz relay and the significance of it in to the trformer?
difference bewteen reverse current and alternating current
Is it required to lay 2 runs of GI wires along with armoured cables from one power DB to another Power DB?
What will be the impact on motor performance if a LT motor is rewound with changed motor winding data as given below:- Original winding data: total 04 wires = 02 wires of 17 SWG + 02 wires of 16.5 SWG. Changed Winding data: total 03 wires of 15.5 SWG wire size Motor rating: 160KW, 740RPM, 415V, ID FAN application. Normal Running Current = 95% of FL Current.