Answer Posted / varun kumar
gravel surface increases the safety limit for touch and
step potential and hence our same design of earthing grid
becomes more safer.
Is This Answer Correct ? | 12 Yes | 1 No |
Post New Answer View All Answers
All the socket in a room become very hot, the Wall was also became very hot and the earth conductor also became live, what in your view might be the possible causes?
magnetizer priciple
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
what is mean by kneepoint voltage? when it will happen? ( my doubt is, if CT secondary is open means ct get saturation or blas? what are factors are required for calculations? plz give currect anws:
Why do we mostly prefer to generate and distribute electricity in 3 phase and not in 4 phase or 5 phase?
Types of test in Switchgears, MCC, NGR and DB's how it should be procced. Can anyone give me the details here or email me to pasuvaraj.k@gmail.com
what is circuit recombiner and how it is different from circuit breaker
what are the breakdown voltage rating of mini- curcuit'transfarmer!
What is the most essential condition for the voltage build up for a d.c. Shunt generator?
DIFFERENCE BETWEEN NORMAL TRAFO AND THRISTER TRAFO?
why we cannot protect 100% winding of an alternator by using differential protection?
Could Please Explain briefly. Why used stabilizing resistance series with High impedance bus differential protection relay.
Direction of flow of active power and reactive power with logic?
I am doing apprenticeship training at HT switch yard in NLC. How can i get electrical c license. ??? What r the rules for getting it as an apprentice? ??
Why the output of OP-AMP is always less than Vcc?