difference between transducer and converter in instrumentation
Answer Posted / mastersensor80
Well, transducer convert the physical parameter like
PRESSURE,LEVEL,TEMPERATURE & FLOW etc, to an electrical
signal that can be used for the purpose of moitioring or
control further signal conditioning is required.
converter in process drawing & P&ID drawing we refer to it
as I/P OR P/I converter current to pressure or pressure to
current.more or less converter & tranducer sound the same.
Is This Answer Correct ? | 16 Yes | 1 No |
Post New Answer View All Answers
i need some objective type questions in instrumentation
Why is it necessary to use compensation leg to measure the liquid level in a closed or pressurized tank?
what is maxdna ?. explain about the software details.
Explain types of valves?
protection relay watchdog contact operation?
how can be calibrate flow indication transmitter (rosemount) it shows excess milli amps nearly about 24 ma on full scale, but its scale was set on 20ma on full scale..???how can be simiulate..???
need to calculate flow rate with the help of dp range and orifice bore dia and size. range is 0 to 400 inwc and orifice size is 12 inch 150 # rf and bore dia is 7.180 inch. need to calculation for flow rate
Hi, Is there any smart plant instrumentation design training institute in Bangalore?
Why is the orifice tab provided?
WHAT ARE THE INSTRUMENTAL DIAGRAMSOF VALVES?
the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove
how to convert MA in to measuring values..and how mwasuring values into MA ?..plz ansr.i have intervw
which processor is used in dcs.
What is the Working principle of Dozing valve?
What you mean by multi stage control vavles?