what's the reson that,Load is not same on VFD I/P and O/P
Side.whenever DOL condition load is same I/P and O/P side.
Answer Posted / sindhejs
We know that Power out=Torque*speed in rps.
Since in DOL condition there is no speed changing means no
change in power out,while in VFD there will be speed
changing using the frequency control,so the power out
changes from power input in VFD(Assuming that torque is
constant).
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
for 4 MVA , 33K.V/6.6K.V transformer. secondary side the connected load is 3000H.P. What is the rating of capacitor bank to be insttaled.
What is the use for cable entry in control room?
what is the significance of terminal voltage and phase sequence in the operation of paralleling of two generators?
how to Select Lighting arrester? What r the parameters to be considered for the selection of Lighting arrester ?
various transmission tower like .,D tower ,K.C.O tower ,C.C.O tower,K.C.R tower ,C.C.R tower ,H.C.O tower in different tons.
What is the rating of a circuit breaker needed for 300 kv load in 33KV supply line of 33/415 transformer ? Whether 800/1200 amp vaccum circuit breaker can perform for a 33 KV line in input in 415 volt in output of the transformer ?
What happen when change order of CT in GIS feeder?
How to measure the Harmonic Distortion of UPS ie THD?
what is W.T?specify the acceptable range?
two way ckt diagram can be drawn by how many ways? give diagram
What is Meter MF if External CT Ratio is 150/1 , PT Ratio is 132/110 Meter CT Ratio is 200/1 & Meter PT Ratio is 110/1
Why open circuit test of transformers is conducted at rated voltage??Why not any other voltage??
Can the output voltage of a rectifier be greater than the input AC voltage without the use of any voltage multiplier in the circuit??please provide the explanation too..
WHAT IS SPEC OF CLEANROOM MOTOR AND LIGHT FITTINGS?
What is online and offline ups? how does it works?