Answer Posted / indrajeet
In parallel operation the process of removing non cricital
loads during undesirable eventsis called load shadding.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
how to calculate the loss tangent of electrical cables
I have a 380 KVA DG set. How can i find out 1. My Fuel Consumption per hr ? 2. Electricity produced in 1 Hr. ? 3. If load varies then how does it affect fuel consumption & electricity produced ? Please HELP !!! Really need an answer.
at what rate the micro controller increment its timer....is it 1micro seconds or 1/(12*10^6) seconds
can anyone explain 11kV 3core cable megger,hi pot test procedure with connection details?
what is the meaning of number in (11, 31, 61,14, etc. CDG11, CDG31, CDG61, DDT32
what is the difference between interconnection and intraconnections in the circuit diagrams
why only exciting current is shown not primary current in transformer???
What is polar plot?
What types of high speed CMOS circuits have you designed?
If UG power cable both ends are to be earthed or what? If not why?
i am completed my degree(B.E EEE) 2014 anychance to get electrical licence plz help me
Why does increasing the magnetic flux in the main field of a d.c motor cause the armature current to reduce??
with 3 phase board on a 63 amp rcd is it ok to have 6 electrical showers 2 on each phase and what problems could happen
State magnitude criterion.
What is Plank's Law?
