What is logic behind the use of Steel bar insted of gold
bar?
- 10 Answers
- 14248 Views
- Rites, I also Faced
- E-Mail Answers
Answer Posted / mayank
Temperature variations in steel are too low to compare to
other suitable materials
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
Define polar co ordinates.
How can i display 5 asterisk and another 5 asterisk )?
Can we use Polystyrene as a Bitumen modifier !! if so is it a good MS research topic ? and what type of laboratory tests will be conducted during Research work ??
how we can find sieve #4 is 4.75mm?
What is standard Sand? What is Regime condition? What do you mean by the core trench in Earthen Dasm? What is soundness test for cement? When negetive shear force takes place in a R.C.C member?
Under what circumstances should pot bearings be used instead of elastomeric bearings?
how to check and keep control on the wastage of material at site
What is the Systematic Responsibility Site Engineer? Who are the above and under co-oridinating ? What is office & Site co-ordination of Site Engineer?
roll of DLC in road constructions
how to calculate cut length of re-bar in a circle . because we not place same length of re-bar in whole circle maximum in center and minimum at corner so how to calculate middle bars???
how to tie 10 legged stirrups
how to calculate load for a bungalow and 1column carry how much load if the size of column ,9"*15" .....or total structure load......
Design a cantilever type retaining wall to retain sand for 4m above the ground. The sand fall slopes at the rate of 1 vertical to 2 horizontal. The weight of sand is 18000 N/m3, the angle of repose being 30. The safe bearing capacity of the soil is 200 kn/m2 at 1/25m below the ground level. Use m 15 concrete mix.
material required for construction of 1cu.mtr wall (Cement, No of bricks (Brick size 40cm x 20cm x 10cm),sand,Quantity of water
five benefits of using standard terminology in the measurement process
