cheapest instru-- PMMC, EDM, rectifier, thermocouple.
- 3 Answers
- 10128 Views
- ONGC, I also Faced
- E-Mail Answers
Answer Posted / jignesh
rectifier is cheapest bcoz diode work as arectifier and is
cost is only 1 rs.
| Is This Answer Correct ? | 6 Yes | 3 No |
Post New Answer View All Answers
how does we calibrate a square root flow transmitter ,give an example and explain it step by step like range calculation , calibration hook up series connection , zero check , and how to apply pressure , and if not geting proportional output then what should we do ?
What is the use of GMV in turbine?
why we us isolation barrier in hazardous area how it works to protect the area and please clarify its current flow.
how will you segregate the alarm levels in alarm management system during factory Acceptance Test
can any send me a forbes marshall dtron 316 manual
What is 3 selection available when configure the burnout protection for controller
the 3 most common transmitter protocol being in refinery or qatar gas and aramco.
What is Droop? What is Step/Gradient Limiter in Turbine Governor control?
why is an oxygen sensor used in a boiler stack
How can we use feedback signal frm rtd for monitoring and in dcs for controlling ,then which type of rtd is sutaible 2 , 3,4wire and why ?
What is the principle of capacitance type level transmitter?
what is the input of digital counter during the the calibration time?
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
how u calibrate pneumatic n motorized c/v?
Specify for Cables - Flame Retardant and Fire Resistant?
