what is interlock ckt? why it is necessary in industrial
machines ?
- 2 Answers
- 7428 Views
- IOCL, I also Faced
- E-Mail Answers
Answer Posted / kkrameshkumar
Interlock ckt or generally interlock means providing safe
conditions for startup and running of industrial
machines.For example, In some machines cooling water is
required for startup and lubrication oil pressure should be
available. In this above machine interlocking system is to
be done with cooling water flow and lubrication oil
pressure to avoid any unsafe condition for the machine.The
machine can be started only if both the conditions are
satisfied. During running of the machine if any one fails
then the machine must be tripped. Interlock is necessary in
industrial machines for safe operation of the machine as
well as the process.
| Is This Answer Correct ? | 26 Yes | 0 No |
Post New Answer View All Answers
what is the difference between attemperator and desuperheater ?
how is work pressure switch& level switch?what is the principle of this?
How to calibration a control valve?
Sir , i have completed my M.Sc In Instrumentation and presently working in Maintenance department 3 yrs Exp , is there is any possible for work in offshore ..
plz you help about Que paper of mahagenco previous your,any model paper relad to it{maharastra power genration}
how many maximum enter 2mm Dia solid cylindrical pipe into 8mm Dia hollow cylindrical pipe. give answer with calculation.
Why all the drains(Gland sealing,ESV,Casing inlet etc) are directly connected to the flash tank instead of hotwell of the condensor in the power plant? My Email Id:naba02222@gmail.com
can we create an interrupt in plc through scada?
what is RTV function in in process control?
hii my name is sujith...i am preparing for HPVL GET 2010... so ,,,pls help me by send any previous questions or material to my site.....(Msujith_12@in.com) thank q
How to Calibrate Flammable gas detector in field
Explain the working of rota meter.
Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?
what is the current pay package for an instrumentation engineer having 2 years of experience in cryogenic technology???????
What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.
