why is the vector group analysis done in transformer tests
- 28 Answers
- 66970 Views
- K K Rao, Lloyds, Nicco Engineering Services Limited, Qatar Petroleums, I also Faced
- E-Mail Answers
Answer Posted / saksh
to check the phase angle displadement so as to know the
power factor itis lag or lead
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
Does the motor power displayed on the Motor name plate is the mechnical power motor delivers or it is consumed power from the system?
main difference between ac and dc?
sir, what is the importance of Fault MVA. how to calculate fault mva of 33kv substation connected by 6.5 km line(single circuit with equal spacing) with 110/11kv transformer in 110kv susbstation.the fault mva on 11 kv bus in 110kv susbstation is 208mva.
How to do fabrication , busbar and wiring cost for : 1. LT Panels 2. C& R Panel
diff. between tension mode & speed mode
which metal is use in shunt
what about the power of wattmeter at starting and loding?
In HI POT test what is reason for applying the AC VOLTS and DC VOLTS in different applications what is the nessesity for this ?
How do i carry out or know the vector group of a Dyn1 and Dyn5 transformer
1600 KVA ka transformer hi aghar lt side par 800A aur voltage 420 ho to HT side ki cable ki rating keya ho gi?
What is the function of attenuator in cro?
how many Classification of fire extinguisher
when ac current flows thru d coil of a contactr,it energizes,magnetic field attracts d contact of the coil...nw wont dt ac current in d contct induce current back on to d coil thru mutual inductance leading to high currnt in d coil
how to calculate voltage drop and followed by cable calculation?is there avail in formula?
What are the differences between single phase and three phase?
