Why we should use delta connection in primary and star
connection in an distribution transformer, which converts
400v a.c. voltage to 33kv.
Answer Posted / jitender kotwal
AS the transmission line are designed in KVA rating which
are so to reduce the size of conductor and to reduce the
cost so at primary side it is always Delta connections and
for distributaion site it is star cinnection with a line
voltage of220 volt and all electrical equiments are
designed for the same voltage in india
Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
why we use the 100% and 95% stator earth fault protection for the synchronus generator ?
Is it possible to measure the voltage of a battery from a single terminal?
What is the emf equation of a transformer?
Dear sir, By which formula u can calculate for a particular kv line there is a range of mw.
Is there a diode made that works with AC 120 volt 20 amp? If so can it completely stop all current flow in 1 direction at all times?
Show the schematic arrangement of diesel power station layout and give its principle of operation.
how to synchronize 3 phase slip ring induction motors of different ratings.
why we used ZNO in Lightning arrester.
why Y CONNECTION IS BETTER INTERMS OF EFFICIENCY AND P.F FOR A LAOD LESS THAN 40% AND WHY AFTER DELTA IS BETTER FOR > 40%
salam,hi, i need to know what the spesification of 300amp msb...
to hook up ten 50 amp rv pedastels at a lenth of 600 feet from the service what size will my service need to be and the size of wire will I have to run to each pedastel in series??????
Why increase in current leads to increase in conductor temperature?
What is gain margin?
why Induction Generators are not "Black start" ? and apart from WTGs where this types of generator are generally used?
why capacitance effect is predominant in underground cable transmission and inductance effect is predominant in over head line transmission?