what is pressure relief valve in D.G ?state its function?
Answer Posted / sunil guru
elobrating the above answer..
pressure relief valve is used alonge with the BUCCHOLZ RELAY..
whenever there is an incipient fault in transformer due to
oxidation the gases are produced in the oil ... which expands
the oil so to auto relief that valve we use pressure relief
valve...
regards
Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
In siemens PLC, why do we want to move the data ?
Is there a diode made that works with AC 120 volt 20 amp? If so can it completely stop all current flow in 1 direction at all times?
Hi Friend I am used multimeter to measure the voltage between R Phase(SS1) to R Phase(SS2). In SS1 is connected with UPS loads. But I am getting voltage between these 2 R Phases. Please give some idea friend
how to CHECK CT AND PT AT THE FAULT OCCUR IN GENERATOR RELAY PANEL .
What is the effect on power factor, shown by a trivector meter; incase of reverse phase sequence. If the power factor of a system is lag what meter will show in case of reverse phase sequence connected to the meter. and What in case of lead.
why current is constant on d.c?
How does "OUT OF STEP" relay ,for Synchronous motor protection, work?
How i can calculate current of cable according to ares?
1.what is difference between ATS & STS main use. 2.what is difference between ACB& VCB With symobles,and main partes, manimum range. 3.How many types of relays and main function.
sir vizag steel ka junior trainee ka paper kitne number ka ayega
1.what is mean by 8/20 micro sec waveshape
please suggest some good universities with low cost iam in totally full confusion so please help me my profile gre 283 and ielts 5.5
What are the advantages of the three-phase motor over single phase motor?
i applied for the ap transco please forward the freqventley asked QA