Based on the DR AND BDR discussion i want to put one question
the question is
what is the name of protocol which is responsible;e for DR
and BDR selection
- 7 Answers
- 6897 Views
- Patni, I also Faced
- E-Mail Answers
Answer Posted / ram ji agarwal
DR and BDR election process is done by OSPF protocol. DR
will that system who has lowest ospf priority and if all
the routers have same OSPF priority so that router will be
DR that has highest ip address all other who has higher
ospf priority and lower ip address than DR that will be
elected as BDR.
| Is This Answer Correct ? | 9 Yes | 1 No |
Post New Answer View All Answers
Can you explain encapsulating, carrier and passenger protocol?
How is rip different from igrp?
which defined peer ip address an local subnet belong to crete? (Choose two)
Does a bridge divides a network into smaller segments?
Define routing?
Your company has been assigned the IP address of 201.222.5.0 and require having 20 subnets. As the company’s network administrator, find the following: a) the subnet mask (2 marks) b) the number of useable subnets (2 marks) c) the subnetwork address for the 4th subnet (2 marks) d) the first usable IP address for the 4th subnet (2 marks) e) the last usable IP address for the 4th subnet (2 marks) f) the broadcast address for the 4th subnet. (2 marks)
Explain how many types of ends in wan?
How many hop counts are by default and how much you can increase in eigrp protocol?
When we do default route?
What is a vlan? What does vlan provide?
After how long eigrp protocol advertise its routing table?
How many types of ends in wan?
How does Hold-downs work?
Which mode we can't skip when we come back from interface mode?
If there is only 2 host in bus topology is that possible collision accord?
