How we can calculate what type of supply we need for an
example sometimes we take 11 KV and sometime 33KV from EB ?
- 4 Answers
- 5264 Views
- I also Faced
- E-Mail Answers
Answer Posted / s.a.k
Electricity is generated at 11 Kv, Stepped up and
transmitted over long distances at either 128/66/33 kv to
distribution substations near to the load.
for industrial purpose, 33 kv line is used as per the
requirement & for domestic purpose maximum 240 volts.
| Is This Answer Correct ? | 3 Yes | 3 No |
Post New Answer View All Answers
Explain the function and difference of Restricted earth fault, simple earth fault and sensitive earth fault with connection diagram.
is it possible to test of bus bar in high rise building without completed full floor ?
how we can calculate power factor in single phase & three phase ?thank u
What is steady state response?
how to calculate micom relay earth falt time and current sertting
When we use 3 terminal resistor?
What happens if we run alternator on under frequency?
difference bewteen reverse current and alternating current
how line turns ratio changes in 3 phase with change in connection
What about electrical Units. discrive in detail
What is main cause of cable's terminal point burned in Lug on high temperature although lug and cable selection is ok as per stantard and also tightness is ok as per situation. so please take in deep and tell correct answer thanku.
Is it possible to measure correct value of earth resistance & cable insulation ristance with out disconncting earth lead & both sides of cable ends? If not, any other method to measure ER & CIR with out disconneting from the system.
WITCH CARDS IN USE IN FIRE CONTROL PANEL.
while doing high potential for 11KV 3 core cable how much leakage current will obtain?, what will be acceptance value?
What Is HO factor in power selection
