in our sub station why we step down firstly 33kv\11kv then
11kv to 430v. can we direct step down 33v to 430.v.
- 7 Answers
- 12418 Views
- I also Faced
- E-Mail Answers
Answer Posted / arup
for the industrial purpose we have to step down the voltage from 11kv to 430 v.no we can't step down 33kv to 430v
| Is This Answer Correct ? | 2 Yes | 11 No |
Post New Answer View All Answers
why do we carry out winding resistance test?
why core is useful for a transformer ?and also in its operation ?
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
1 hp is equal to how much watt?
What happens if i apply 500V to 440V rotary Switch ?
What mean by MLTP
what is two point starter?
what is meant by k-rating in isolation transformer?what is k9, k14 stands for?
it is in our knowledge tht right plug of supply of residential suppy system is phase n other is neutral...howevr the battery charger of mobile works in both ways...i mean it is not restricted in only one direction.ny of the holder of charger can hav phase .so y is it not lik tht phase of supply must b connected 2 phase of charger...?
how to identify vector group of three phase transformer by voltage method?
why we use the 100% and 95% stator earth fault protection for the synchronus generator ?
How to Calculate KA Rating of Main LT Panel
what happen ehen synchronisation is done at below rated speed
how much GROUND & NEUTRAL VOLT maintain in data center.
how to calculate the earth fault current
