Answer Posted / m.senthil kumar.areva
power factor is the cosine of the angle between voltage and
current.....maintaining of power factor is essential thing
for improving the power factor capacitive load to be added
on the circuit for decreasing thee power factor inductive
load to be added on the circuit......
| Is This Answer Correct ? | 12 Yes | 2 No |
Post New Answer View All Answers
How to calculate the sag of OPGW during stringing???
What is the use of bundle conductors?
what is meant by power and distribution transformer ?
describe the phenomena of vacuum interruption in C.B
whats the application of voltage regulation? and whats the voltage regulation's device?
how we can find of current direction(supply comming/out going direction) when a transmission line passing through sides.
what is dry and wet frequency withstand voltage? why & where it is used??
what happens to the supply voltage if there is any change in frequency?
What is difference is of VSD,VFD,VSDS, are they the same as the direct current to control dc using above mention
what will happen if frequency is below 50 hz?
what is the star delta connetion and how can do it a three phase motor with control witing with picture
How to measure power in 2 or 4 or n phase circuit? Please give me a formula.
I'm looking for a mnaual set for a Teradyne J750. Softcopy would be preferred but I'll take what I can get.
In how we connect watt meter for open & short circuit test of a single phase transformer.
what precautions to be taken while desigining a LT,HT panel. Eg-LT panel PCC panel with ACB installed. HT panel VCB panel with VCB installed. & what is main diffrence betwn IP54 & IP55 construction of panel.
