Interested to Buy Any Domain ? << Click Here >> for more details...
what is the differenc between A.C. and D.C, which is more
dangerious?
- 4 Answers
- 7718 Views
- I also Faced
- E-Mail Answers
Answer Posted / ankit
ac is alternate current.
Dc is direct current.
In our house 230 V ac is used. If u get
shock.. There is a chance to escape as
voltage is low and ac current crosses zero
at every half cycle...
But dc current can do much damage to u
as it does not crosses zero...constant full
dc voltage is applied to u.
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
where rlc series ckt used?
How u can give the overload setting to any motor protection relay for a HT motors with formula and Example?
sir, what is the importance of Fault MVA. how to calculate fault mva of 33kv substation connected by 6.5 km line(single circuit with equal spacing) with 110/11kv transformer in 110kv susbstation.the fault mva on 11 kv bus in 110kv susbstation is 208mva.
what is the physical connection of a analog i/p to a analog i/p module (ab plc)and through a analog o/p module(ab plc) to a analog o/p . and how all the process control by scada
The knee point of a current transformer is normally unique and known.So why in the nameplate of a CT they put the minimum value like this Vk> 400v.
Please define ohm’s law for a.c (alternating current)?
for a 500 KVA connected load, I calculated 30% of capactor for power correction. Even after using 225 KVR capactor PF is not improving. What could be reason for low Phase correction factor?
The transmission does not have options: a)Partition noise b) Flicker noise c) resistance d) Short noise and reason
for 4 MVA , 33K.V/6.6K.V transformer. secondary side the connected load is 3000H.P. What is the rating of capacitor bank to be insttaled.
What magnetic circuit is formed in berry-type constructions and why?
What are the main advantages of bode plot?
a governer in an Ic engine controls the
How grounding is different than earthings?
What is the difference between solid grounding and impedance grounding?
at what basis/standard we have to arrive the current density of aluminium/ copper in busbar?
