In alternator generally we give DC voltage to field of
alternator but field (excitor)produce Ac & converts into DC
by rotating rectifier(RR ) then fed to rotor .my question
is why we cannot give dc voltage directly to rotor instead
of Excitor & RR ?
Answer Posted / arun pandey
First-Voltage regulation of AC is easier than DC which is
controlled and regulared by Automatic Voltage Regulator.
Second-DC Power given to alternator for field excitation
having very high current,for feeding this type of supply
system size and cost of exciter becomes excessive high and
size of Automatic Voltage Regulator and its heat
dessipation will cost also that why it become in efficient
give dc voltage directly to rotor instead
of Excitor & RR ?
Arun Pandey
Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What is the real function of reverse power relay in generator panel while syncronising?
What is the magnetic field (coil DC ) of Turbo Expander?
sir vizag steel ka junior trainee ka paper kitne number ka ayega
Metal covered multiconductor cables shall employ a marker tape located within the cable running for its complete length in lieu of cable surface marking. Is it true or false?
A cylindrical wire is compressed in length by 10%. The percentage decrease in the resistance will be?????
What difference between ref protection and differential protection ?
what are the tests comes under the type test, what tests comes under routine tests.
Explain the different regions in frequency response?
I NEED RRB SYLABUS FOR JE ELECTRICAL ,PLEASE SEND TO MY E- MAIL ID joo28_eee@yahoo.co.in
The series field winding has low resistance while the shunt field winding has high resistance. Why?
sourse is 66 KV / 350 MVA, transfarmer is 1000 KVA 6.6 / 0.415 kv, iF fault is 28.75 MVA on 0.415 KV Bus then calculat the Transfarmer Impidance
ITI r/tv trade APPLY (J.T.O VACANCEY) ALSO INCLUD AITT ELECTRONIC,WRITEEN XAM DONE 23.03.10 BUT NO RESPONCE WHY ANATHER ID gopal_gh007@rediffmail.com
why genarator genarating voltage 11 KV?
what is the safe meggar values for motor, transformer HT, LT and Cables? IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace. why we generally use 3.5 core cable or in other word 1/2 core for neutral and also confirm me that in balance conditiob(3 phase)current in neutral will zero
how generator load test is conducted?what are the steps?