Interested to Buy Any Domain ? << Click Here >> for more details...
voltage at generation stage is usually- ?
a.11kv b.33kv c.66kv d.220kv
- 12 Answers
- 21789 Views
- I also Faced
- E-Mail Answers
Answer Posted / sudhir kumar
since all the voltage generation are in average and we use
rms quantities for computation. so we need to convert the
average to rms simply by multiplying the form factor 1.11.
thats how the voltage levels are in the multiple of 11.
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
What are dcs and plc?
why power factor is important?
Advantages/Disadvantages of earthing of neutral bus on MSB instead of separate neutral earthing for transformer/DG sets feeding to MSB
physical identification of HT & LT panel
what is the function of Moulded case circuit breaker, why it is called Moulded?
what is class of SPD and dittels of all class ?
what is the use of static frequency converter and static excitation equipment? and where it is employed? for what?
dear sir/madam i want to get some knowledge about RRB EXAMINATION(section engineer) 1- what is minimum cut off 2- wht portion is major portion . 3- can any body provide Sample paper. thanks & regards ashish
State the types of distortions in amplifier?
i had aplied Hindustan Petroleum corporation limited for the post of maintenance technician -Electrical,i want model questions,if anybody have please send it or please advice?
What is the lifetime of a Thyristor? Is there a recommended lifetime for thyristors after which they should be replaced?
Installation resistance for whole installation of 16 kva & 25 KVA DTRA a) Between each conductor b) between conductor to earth c) installation resistance for each apparatus, each conductor to earth d) earth resistance for the system of earthing
What is the difference between shortcircuit current, rated current of cable & MCB with example? What will be the size of cable required for 5.5 KW motor (Full load current 10 Amps approx.), Starting current with DOL is 120 Amps. Aprrox. Short circuit current with LLLG fault is 2000 Amps Approx.
Transmission voltage is kept 11KV,33KV,66KV,132KV,220KV due to form factor. What happen to 400KV and 765KV transmission voltage?
what parameters should we check to reduce the power bill
