tell me quantitys of matal, sand and cement in 1:4:8 and
1:2:4
- 9 Answers
- 149170 Views
- AVL, Infosys, NCC, SPCL, Swapnapurti Developers, I also Faced
- E-Mail Answers
Answer Posted / tejaswi
for 1 unit of cement , 4 units of sand and 8 units of
matal are added in 1:4:8 mix.
And for 1 unit of cement, 2 units of sand and 4 units of
matal are added in 1:2:4 mix.
| Is This Answer Correct ? | 166 Yes | 39 No |
Post New Answer View All Answers
There are two buildings one taller and one shorter whose time period will be grater and similarly the frequency ?
For the symmetrical continuous beam shown in figure, Prestressed with a force P = 1500 KN along parabolic curve as shown, compute the extreme fiber stresses over the central support for the uniformly distributed load of 24 kn/m. Use load balancing method.
What are the different methods for drawing an arc?
Kindly post me previous year interview questions with answer for post of DY. Manager (civil engg.) for GAIL, NTPC, IOC, OIL and ONGC etc.
Sir how to find cutting length for footing steel bars in the shape of "u"
I want to know about rolling margin of steel :- For eg. If 2nos. bundle of 8mm dia steel with17 rods each of length 12m comes to store. During testing of 1m rod of each bundle it was found that 1rod has weight .405kg/m while other has .385kg/m. Now what will happen in case of steel payment and measurement payment ? Regards,
What applicable rate of wct in bihar
length where bent up is made in slab of bridge from one end
WET BULB TEMPERATURE AND DRY BULB TEMPERATURE?
115mm thickness brick work how to required mortar
1. 1. The mass of a chunk of moist soil is 34 Kg and its volume is 0.012 cu. Meter. After drying in an oven, the mass reduces to 14.25 Kg. Determine the water content, the density of moist soil, the dry density, void ratio, porosity and degree of saturation. Take G = 3.25
what will be the cost of thickness of 125mmor rcc measurement of 52x33.75 feet
What is the significance of cost estimate knowledge for an architect?
what is kribs is supporting?
How to find coloumn vertical cut length floor to floor & lap + bend or anything plz clearfiy
