Interested to Buy Any Domain ? << Click Here >> for more details...
Why we should use delta connection in primary and star
connection in an distribution transformer, which converts
400v a.c. voltage to 33kv.
- 15 Answers
- 49354 Views
- ABC, Kirloskar, Sify, I also Faced
- E-Mail Answers
Answer Posted / nitin palaskar
we should use delta connection in primary and star to
secondary because in delta line voltage = pphase voltage
and instar line voltage = 1.732phase voltage hence we get
173.2% more voltage hence we use delta star transformer.
| Is This Answer Correct ? | 11 Yes | 3 No |
Post New Answer View All Answers
in our all power plant have connected in grid and grid voltage and plant voltage is same, but as per as electrical concept the power will transmit from high potential to low potential but here altough same,then how power transmit from power plant to grid.
What are the material used for resistor?
Maintenance of transformer???
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
What is marx circuit?
How phase displacement change in the over current relay coils.
(1)Can earth and be conected together (2) what is the diferent between earth & neutral
What is the formula to calculate a three phase alternator
what is LSR?
What is the unit of magnetic flux density?
WHAT IS START TO INDUCTION MOTER IN STAR TO DELTA OF >5HP ?
What are factors to be considered while we selecting the Core Balance Current Transformer for Earth fault protection
If we have 11 kv RYB Phase single core cable near about. Then wht effect and losses
what is the transformer turn ratio formula and give some examples?
what happen if drive input fail momentry at 48.5 HZ frequency?
