Answer Posted / arthi.p.l
if you take in case of lightining,in order to avoid shock
over the building that is on earth.we use to keep lightining
rod at the top of the building so the answer would be
LIGHTINING ROD
Is This Answer Correct ? | 4 Yes | 9 No |
Post New Answer View All Answers
why we not used 11kva as a direct our electrnics component.
What is inverse definite minimum time lag relay? Where is it use?
Practical condition in 400KV Sub station:- Breaker(open) , isolator(open), Earthing (close) at both end e.g A & B. Now Open A Stn Earthing than Open B stn Earthing (Which have a 50MVA reactor) , AND suddenly show R,Y,B phase 704KV,573KV,118KV respectively. Que is without closing of breaker how it is possible.???? My Whats app No:07621840498 for Further Discussion. Pls experts suggest.
How to assume answer to electrical questions
What is the difference between Droop vs Isoch Control?
Can we use Ccapacitive voltage transformer directly for metering purpose?
Why GRR starts from 60% of motor speed why not less than 60%?
How can eliminate noise problem inside temperature controller temp. variation due to contactor chattering problem.
if the number of poles generated in stator and rotor side of an induction motor are different then what will happen and why?
Batteries. What is the difference between Lead and Nickel batteries ?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
what is the effect of back reactive power on the generator ?
If only R Phase is connected in 2 pole elcb, n is not connected than it will work or not in ground fault.
what about GD square and its important for motor design?
On what basis do you decide the ONAN (Oil Natural air natural) or Dry type transformer for a project?