pleasee tell me the risks and hazards of a Cable Jointer
job? Thank you.
Answer Posted / mohammed amjath
As a cable jointer he should follow the safety first.A
jointer should use the measurement drawings in the
jointingkit.if he is not using it may cause shortage of
cable.Improper crimping will cause failure of cable
joints.Then the goverment authority will cancel the licence
of the jointer.A good jointer will first do meggering of
cable,Proper mesurement,And good crimpping.
Is This Answer Correct ? | 10 Yes | 0 No |
Post New Answer View All Answers
what is allowable ac mixing in dc
what is relation between ct and pt ratio with multiplication factor of a energy meter? is there any other factor on which multification factor depend?
Control wiring of a dol starter for forward and backward
How dia computation perfomed in cold rolling mills .
how technical is calculated in 11kv line and lt line
At what speed 1 HP motor can run an electric car of weighing 400 kg?
Distinguish between nuclear power station with thermal power station for initial cost, starting period, cleanliness, and transportation of fuel
state the working of discharge lamp?
Why the output of OP-AMP is always less than Vcc?
Why does the adjacent zone of protection overlap?
WHAT IS MEANT BY DERATING OF THYRISTOR?
how works inductive &capacitive sensors?
What is Delta Connection? What is meant by Forward Delta & Reverse Delta & How Will be the Connection in Power Transformers?
how tto ingress mw in turbine explain.procedure ?
Who many reason of ignition fail ?