Interested to Buy Any Domain ? << Click Here >> for more details...
is starting current of induction is high or stating current
of ransformor is hign ,for the same rating
- 12 Answers
- 16470 Views
- BARC, I also Faced
- E-Mail Answers
Answer Posted / edfwe
Sayan is right.
IM is equivalent of transformer with short circuited
secondary.
| Is This Answer Correct ? | 4 Yes | 3 No |
Post New Answer View All Answers
what is transient enclosure vltage , very fast transients, very fast transient over voltages
what is the necessity of under ground cables ??
Practical condition in 400KV Sub station:- Breaker(open) , isolator(open), Earthing (close) at both end e.g A & B. Now Open A Stn Earthing than Open B stn Earthing (Which have a 50MVA reactor) , AND suddenly show R,Y,B phase 704KV,573KV,118KV respectively. Que is without closing of breaker how it is possible.???? My Whats app No:07621840498 for Further Discussion. Pls experts suggest.
HOW WE KNOW IN PHYSICALLY THE CONTACT SURFACE OF A VACUUM INTERRUPTER IS GOOD OR GOING TO DAMAGE IN A VCB AFTER ABOVE 500 TIMES OPERATED.
What is the ratio of Booster transformer?
On what basis do you decide the ONAN (Oil Natural air natural) or Dry type transformer for a project?
What is installed in PAC that is control the humidity
How servo stabilizer works.
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
In the N-series schneider reclosers. What is the difference between current during fault time and current at tripping? This appears in the Event log in an event of a trip out.
Differentiate between induced emf and self inductance?
Is it possible to make a 5P10/ CT Ratio 50/1A Burden 5VA
While testing a ZCT what parameters have to check or measure?
what is the transmission loss for electrical supply? specifically a large shopping complex where the grid is half KM away, what will the % of transmission loss? is there any transmission loss for captive unit generation for above set? thanks
Explain what is clipper and clamper circuits?
