could i arrange a faulty and healthey battery bank togather
in parallel , if your ans is not then why?
- 3 Answers
- 4185 Views
- I also Faced
- E-Mail Answers
Answer Posted / aree dewan
yes but with this connection the voltage will be constant
bur current will increase.
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
What is reactance, reluctance,capistance, pls give answeer in hinglish and be simply Jo asani we smajh m aa jaye
Can anybody just suggest about the scope of Electrical design with ETAP software?Just guide me?
How much ph is maintained of water electrolyte which is used in LRS for 1200 kw slipring induction motor ?
In EDO ACBs what is a purpose of closing coil and motor, what is the operation of these devices are they inetconnected. means if we give supply to motor and by BCS we charge Closing coil,what exact is operation is and how it charge a spring of ACB. Sir if anybody has an wiring diagram please send me the link to operate and EDO breaker.
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
How to calculate approximate load loss of a distribution transformer by knowing %ge imp of transformer?
what is breathing?
I completed my BE EEE degree 2006 .... which license should i apply .... ?????
what is load vs Torque curve & why it is used?
Give some differences between open loop and closed loop control systems.
importance of reactive power management
what is the function of bearing in dc mchine" and where it is placed
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
What is miller crystal oscillator? Explain its operation?
which connection is safer series or parallel?usually which connection we prefer at home?
