what is lightning arester?generaly which type of used in
industeries? why its used?
- 7 Answers
- 9892 Views
- Essar, I also Faced
- E-Mail Answers
Answer Posted / m.jagadeeshraja
The Lightning Arrester is used to prevent the particular
component(consider Industry, Shops, Home,.. etc). When
clouds collided each other the charger present in clouds are
discharged, when these forms lightning(in terms of MEGA
AMPS)and fall where the low potential areas. So Lightning
Arrester made as low potential and less resistance path so
these charges are DUMPED here.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
how technical is calculated in 11kv line and lt line
i have interview in Pepsi company what type of question will ask please send the question and answeer
difference between high and low impedance BUS BAR relay??
A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is observed the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?
If symmetrical fault occurs at the terminal of a synchronous motor then how the motor will act...explain it..
What is kirchoff ’s current law (kcl)?
why effective resistance should be more than static resistance in transmission line?
What is meant by short-pitched winding?
Ceiling Fan and Storage type water heater. Discuss
what is automatic voltage regulator?we can control the vlotage by using fuzzy controller in matlab?why we go for fuzzy?
either water sensor or flow meter,how we observe the water level, f any other equipment are in market ?
In a 3 phase 4-wire system. For a 3.5 core cable if all loads are single phase and balanced, what will be neutral current? will it be sum of all phase currents? Or it will be zero? And if loads are unbalanced what will be neutral current?
how diside ct mf exmp.200/5 ct
what is relation between ct and pt ratio with multiplication factor of a energy meter? is there any other factor on which multification factor depend?
What is the practical way to calculate the cable size for known ampere load?
