Interested to Buy Any Domain ? << Click Here >> for more details...
what is the diffrence between plc&dcs
- 4 Answers
- 9778 Views
- HCL, Hindustan Zinc, I also Faced
- E-Mail Answers
Answer Posted / sharma
the difference between is that we can detect the error in plc
but in dcs we can find the exact point of error.
where the actual problem is.
we can also control the different error at different
| Is This Answer Correct ? | 2 Yes | 5 No |
Post New Answer View All Answers
Sir , i have completed my M.Sc In Instrumentation and presently working in Maintenance department 3 yrs Exp , is there is any possible for work in offshore ..
Derive capacitance to 4-20ma conversion formula / relation in capacitance type pressure sensor?
you must show the examples application and give at least 4 types of transducer/sensors that can minimize the failure during the manufacturing of the resistors.
What is the cascade control
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
we are having yokogawa centum cs3000 dcs in our power plant. i need some of the operator guides NOT to appear in HIS0163 AND HIS 0162 but it shoul appear in HIS0164 HOW TO DO IT?
IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?
How does temperature bath work? How does coil gets heated only by applying some current?
how to do dynolab wind speed sensor loop test, how to simulate value,i have simulate mA 4-20mA but not responding in DCS faceplate, please kindly advice me any one.
how to convert cubic metre per hour to newton cubic metre per hour
Can anybody please let me know Orifice plate sizing calculation formula and step by step procedure
any body please send me the old question papers of ongc test.
How process line mpm calculation is done?
typical loop drawing of a simple feedback control comprising of one transmitter and one control
POSSITIVE PULSE IS APPLIED TO AN INVERTER INPUT.THE TIME FROM THE LEADING EDGE OF THE INPUT TO THE LEADING EDGE OF THE OUTPUT IS 10 ns. THE TIME FROM THE TRAILING EDGE OF THE INPUT TO THE TRYLING EDGE OF THE OUTPUT IS 8 ns. WHAT ARE THE VALUES OF tPLH and tPHL?
