what is Wave Trap? And its Function ? Detail? Where it is Used?
- 7 Answers
- 79001 Views
- I also Faced
- E-Mail Answers
Answer Posted / jay barot
wave trap is a plcc communication in power system which
block the outer frequeny of other power station these are
installed in switch yard i was seen wave trap in
gandhinagar thermal power station and i remember it
| Is This Answer Correct ? | 40 Yes | 53 No |
Post New Answer View All Answers
what is the safety points of vaccum circuit breaker.
how to Select Lighting arrester? What r the parameters to be considered for the selection of Lighting arrester ?
which type of stability limit is higher,steady state or transient? why?
if we install two earth pits with a clear space of 5m without any interconnection,by checking the digital multimeter will it show continuity between earth pits? If so what would be the approx. value
What are the roles and responsibilities of electrical engineer in cement plant
redundant connection in contactor?
What are the application of filter?
when we design electrical schemes of 11/.415kv distribution..wen and were should we show the relays??what is the function of it?for example..we place EFR Relay CT between transformer neutral link and transformer earth.Like this what are the other type of relays we should use?why?where?Explain please..Thank you
What are the causes of unbalanced current on 34.5kv feeder Ia=0.05,Ib= 0.25, Ic=0.15 and In=0.27 prior to tripping current are balance?
what is the working principle of energy saver control panel. please give the complete calculation & theory.
What is the effect on 3phase induction motor if current setting knob of DOL kept at minimum current?
how to changeover ups in this power failur time?
How will A Medium voltage circuit breaker(11 kV voltage level) operate under short circuit fault condition whether It is having short circuit release like Low voltage circuit breaker or relay should be given?
What is power relay?
Explain The Application Of Storage Batteries?
