Answer Posted / prince kumar meshram
from the faradey law of the electromagnatic induction,
whenever a current carrying conductor is placed in a
uniform magnetic field it experinces a force and the
direction of the current and the motion of the conductor
can be found by the flemings left hand rule.
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
if i am in front of transmission line how to know that current direction without any equipment
reason of diode failure in alternator
upto how much low RPM we will run the commercial motor which is run through VFD without any problem occurs in motor.Motor rating Duty is S1 & RPM is 1400.
1 “earthing” for bonding of equipment and circuits to common plant earth electrode potential, 2 “protective earthing (PE)” when this bonding is required for personal safety provisions 3 “grounding” for interference suppressing bonding of screens, sys-tems with ground level 4. low-impedance earthing ? 5.primary earthing system and secondary earthing system what is that? 6.earthing electrode or mesh net earthing electrode ? very confusing , simple but very informative help required ? i will be very very thankful to you guys.
Difference between low impedance and high impedance Restricted Earth Fault
1. Can a 12v DC choke operate a 60v/12w PL lamp ? 2. Can a 230v ballast fire / operate a 60v/12w PL lamps.
Load transfer in 11kv double busbar switchgear - operation.
Difference between shunt, PMG and AREP excitation. Which is the most reliable between PMG and AREP.
Can we indroduce the principle of single phase induction mator to Transformer? i.e. by Producing rotating flux in the transformer.
difference between ac series and parallel circuit
What is the basic rule for block diagram reduction technique?
I have 2 KW electric water heater.I am gonna use it in controlling water temp.so I needed to increase or decrease the heating capacity.is there any electrical-electronic circuit for varying the resistance & so current?
How is the gain affected by the introduction of feedback in a control system.
what the Microsoft .NET framework is?
static chagre
