Answer Posted / p.manokaran
The most common mode of failure is overloading. Operating
forces of the application produce loads that exceed the clamp
load and the joint works itself loose, or fails
catastrophically.it occur in the shear forces and twisting
moment....
| Is This Answer Correct ? | 5 Yes | 2 No |
Post New Answer View All Answers
What is principal work of “O ring”?
In which system does the output not affect the process in any way?
What Is A Closed Loop Control System?
Explain some advantages and limitations of mechatronics?
Differentiate between feedback and feedforward control systems?
What Is Mechatronics?
What is the Expansion of SCADA, DCS & HMI?
What is the expansion of scada?
What are electronic control systems?
Why stepper motor is required?
Do you studied an postgrade?
Name some flow measuring devices?
What is u value?
What is the difference between pressure vessel & column?
What is the Difference Between SCADA and BMS?
