why ct secondary side shortlink provided? its open what
will happen?while running ?
- 2 Answers
- 10668 Views
- Essar, I also Faced
- E-Mail Answers
Answer Posted / aamirali
Current Transformer (CT)is used for measurement, control and as a protection device. We make short ckt secondary of ct because we can measure the ratio and polarity of secondary side. if it isnt short cktd it will not operate under over current on secondary side.
| Is This Answer Correct ? | 2 Yes | 10 No |
Post New Answer View All Answers
i have to install a HT panel, what components, I have to use in this and what will the diagram of that diagram,please tell me each and everything.
which is better to use svc or synchronous condenser why ?
Why use the vcb at high transmission system ? Why can’t use acb?
How to work definite,over pluxing,revers power,OSR relay
give single line diagram of D.G distribution form alternator to main L.T panel?
How are load losses and no-load losses measured at site in a DG set?
what is meant by CT`s saturation ? Can we use Metering CT`s with Protetection CT`s ?
HOW TO TEST A LIGHTENING ARREST ER ?
What is the use of oil in transformers?
What are the site acceptance tests for power cables, DG Sets, LT panels & 30kVA UPS ?
What are the material used for resistor?
what is apparent poewr, reactive power, & active power?
why the difference arise between HT reading & LT reading (submeters fixed in complexes, apartments etc)if the power factos exceed from 0.9 to 1 can the ht meter reads fast?
what is KSR type transmission tower? What is LSR type transmission tower?
what questions will be asked for 11/33KV licence interview APSEB hyderabad. Can any one share question and answers.
