what is diffrances between fuse and breaker protection?
which one is best?
- 2 Answers
- 4424 Views
- Essar, I also Faced
- E-Mail Answers
Answer Posted / aamirali
Fuse and Breaker both are used for protection against short ckt current. Fuse is used for low voltage protection say homes, shops, hospitals, schools etc. While ckt breaker is used for mostly high voltage side say factories, substations, power grid, whole buildings etc.
If we use ckt breaker instead of fuse it is not economical, maintenance & operating is not easy also rating. Fuse is easy to operate in low voltage side.
| Is This Answer Correct ? | 7 Yes | 4 No |
Post New Answer View All Answers
Why auxiliary transformers are not connected in parallel in primary stations?
Mention how NPN and PNP transistor works?
What is difference between unity power factor wattmeter and upper power factor wattmeter? In short circuit test of transformer the wattmeter used is unity power factor type or upper power factor type wattmeter?
what is lrs tank water resistance.
In HI POT test what is reason for applying the AC VOLTS and DC VOLTS in different applications what is the nessesity for this ?
where can i get vijaya electricals limited in hyderabad interview auestions can u give me the website address plz
I have doubt that the supply HZ (very low or high than rated ) may affect the power factor. is it true. ?
what is cathodic protaction?
Please brief working principle & construction of permanent magnet AC Servo motor
how to calculate distance between busbar supporters for LT panel, what are the factors influencing in this design
What are the uses of stepper motor?
What is the application of Dyn1 and Dyn11 vector group of transformer?
How do i perform grounding of star point of Genset (400V) for making connection with step up transformer of DELTA-DELTA (400V to 20KV) ? while Genset itself has its own neutral and grounding bus bar inside genset breaker box whereas we have another neutral and grounding busbar in synchronizing panel next to genset at maximum distance of 6meter, would someone pls advice if we can only perform neutral grounding in synchronizing panel or should we ground neutral on both places inside genset breaker box and synchronizing panel.
I need a formula to calculate the size of cable as per load but in the terms of length. Please Reply me as i search lot of sites but i did not get the answer.
why we use 630mm single core cable for transformer secondary side and why two neutral cable
