Interested to Buy Any Domain ? << Click Here >> for more details...
What is the power ratio between power in Star and Delta
circuit?
- 11 Answers
- 43992 Views
- ST Micro, I also Faced
- E-Mail Answers
Answer Posted / karthick
in star connection
line voltage is=(3)^(1/2)*phasevoltage
line current is=phase current
in delta connection
line voltage is =phase voltage
line current is =(3)^(1/2)*phase current
power ratio=( ((3)^(1/2)*phasevoltage*phase current)/((((3)^
(1/2)*phasevoltage*phase current))
so power ratio is =1.
| Is This Answer Correct ? | 62 Yes | 36 No |
Post New Answer View All Answers
When we have earthing mesh or underground earthing network in industrial plants, weather we have NT-S or NT-C-S kind of earthing system, so eventually weather we must use 4 or 5 wire in 400 volt level (For example 3×150+70 mm2 or 5×150 mm2) in this connection I would like to know exactly the paragraph of IEC or IEEE number
How to calculate KVA/VA rating of PT or CT from primary & secondary voltage or primary & secondary current?
What do you mean by ratio correction factor of instrument transformer?
What is power factor why we should maintain the power factor unless what will happen
how can calculate resistance box for 15 kw, 6 pole, RV-230, RA-42 motor
The ripple frequency in output of fullwave bridge rectifier is a. Half the input b. Twice the input c. Same as input
What are the raitings of Mcb,mccb and Acb in detail ??
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
How to calculate the no of Ceiling fan (1200mm sweep) per unit area?
I have a current transformer with 1 main reading meter with transformer outside the building and a control panel having 5 CT reading meters with black round coils inside the building. I want to know, A) when current pass through the Transformers, will the current be reduced or be the same and after that B) when current pass through the CT meters with black round coils, will the current be reduced or be the same. C) in the above process will the reading of the main meter be same or different, from the total reading of all the 5 CT meters.
how to find the resistance and gap volatage of the diode??
What is the difference between shortcircuit current, rated current of cable & MCB with example? What will be the size of cable required for 5.5 KW motor (Full load current 10 Amps approx.), Starting current with DOL is 120 Amps. Aprrox. Short circuit current with LLLG fault is 2000 Amps Approx.
I WANT BHEL PREVIOUS QUESTION
how to store the thunder power?
What happened if C.T mount at any cable or Bus bar in wrong direction . C.T going on proper work or not . C,T direction is essential thing to properly work.
