tell me about the instrumentation,what is the actual need
of it ?what are the characteristics of a IC engineer ?
- 11 Answers
- 13367 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / raj
measurement.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
can anyone tell me about the basic concepts to consider before to start a PLC panel wiring
1.what is the power consumption of three element drum level control in sugar industries? 2.how to reduce that?
How we calculate orifice plat size???
Is it ok, to use non-contact type Radar type LT, on a tank that is half circular from the bottom side? If yes the, isn't the waves gonna bent in other directions?
please can any one tell me clearly about pid tuning i am confusing about this .how to tune pid easly?
What is force balance principle? State some of its’ advantages.
any body who gone thru recent iocl interview.INSTRUMENTATION questions. I need.
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
hi,i am doing 3 year in electronic and instrumentation engineering. what type of aptitude questions will be asked in a core industries and how can i improve my skills in instrumentation?
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
Derive capacitance to 4-20ma conversion formula / relation in capacitance type pressure sensor?
what is the protection system in solar turbine compressor
1.can you use SCADA instead of DCS,DCS instead SCADA 2.Difference between DCS and PLC,can their role be reversed i.e. role interchange 3.Difference between RTU and PLC
how to commission furnace ( water heater)
