What is the difference between earthed and unearthed cable
- 5 Answers
- 8970 Views
- FT, L&T, Suzlon, I also Faced
- E-Mail Answers
Answer Posted / balaji
1.safety of personal is more in earthed cable than compared
to unearthed cable,because all fault&leakage current will
flow through the earthed armour.
2.we can easily found out the potential drop of earthed
cable by measuring volt between neutral and earthed armour
of the cable.so we can easily sort out the earth fault of
earthed cable .if there is no fault approximat volt between
neutral&earthed armour will be zero.
| Is This Answer Correct ? | 10 Yes | 0 No |
Post New Answer View All Answers
explain why core loss of a transformer is almost constant under different load conditions when connected across a constant voltage and constant frequency.
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?
How can we convert 11 kv to 440 volt without using transformer ?
We need to current density & short circuit calculation at 65kA for aluminium & copper busbar.
description about dry type transformers
how u select control transformer for a mccb panels or any panels?for expample we hav 440 volts maim supply and control volts is 230v?
EHV current carrying parts need to have smooth finish,then how can a 245kv GIS with emery finish can run so long?
if the armature current in a dc generator is ac ( sinusoidal ) why doesnt the sjhape af armature mmf a sinusoidal (ni) ? armature mmf in case of a dc machine is triangular.
What is MS-EXCELL?
Define resonant peak?
Can a generator runs after getting 1st stator earth fault.
sir i have cleared the apti test of EIL held on 15th march and my interview will be in new delhi on 2nd june.i will be very much helpful if u help me regarding the type of interview questions comes at EIL.(URGENT.........PLZZZZZZZZZZ...............)
why we can use 1 to 5V dc
Please send 110 kv sb station full single line drawing(sld)
what is the solution for meger test failed the MV cable?
