Interested to Buy Any Domain ? << Click Here >> for more details...
instead of neutral can we use earth/ground to flow the
current in the circuit
- 2 Answers
- 7084 Views
- Infosys, I also Faced
- E-Mail Answers
Answer Posted / guru
NO
If you are using a single phase load and AC waves are
always Sinsuoidal waves it is not possible to use earth as
Return current path. That is why neutral is provided
| Is This Answer Correct ? | 8 Yes | 3 No |
Post New Answer View All Answers
what happend to DC shunt motor if its field winding insulation becomes slightly weak? will that motor can run on full load or not explain in detail. thanks
EXPLAIN METOD OF IMAGE OF TRANSMISSION LINE/ WHAT ARE ITS PRACTICAL APPLICATION?
What is kirchoff ’s current law (kcl)?
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
If I want to lift the water at a height 50m from ground level through two inch(diameter) metal pipe then what is the capacity of motor pump is required? is it possible in single phase supply or not?
what is the problem when i want to close a circuit breaker by local position it closes well.but when i close it in remote position it trips
what is the method of earthing of a transformer using electrodes?
I have 1500/1A CT If i connect this CT in 6.6KV bus bar means what will be the voltage present in CT?
When are the directional relays used?
How to calculate the multiplying factor for energy meter with ct ratio given
what is the use of vcb & isolator in substation?
What is the problem of internal failure in ship engine telegraph system norcontrol?
For small size, high frequency coils, the most common core material is- a. )Air b. )Ferrite c.) Powdered ion d.) Steel
Define coil span?
Hello Friends, How can we recognize the CT Star Point is S1 or S2 in case of Electro Mechanical Relays and what is meant by Restraining coil in relays and what is the purpose of that.. thank you in advance..
