Answer Posted / pragati
A bushing is an electrical engineering component that
insulates a high voltage conductor passing through a metal
enclosure.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
Stator of 3-phase IM has 3 slots per pole per phase. If supply frequency is 50 Hz, calculate the speed of rotating stator flux A 1000 rpm B 500 rpm C 1500 rpm D 1440 rpm
state the working principle of incondenscent tube?
What are IP protections used for electrical panels, JB, equipments installed in explosive zones like Petrochemicals, Oil & gas
is it possible to start a motor in felid connected to a remote mcc
Either the Armoured Earthing strip of HT 3 core cable have to pass through CB CT or not , why ???
what is p.s impedance measurement test in earthing transformer?
Why is remote backup preferred to local backup?
Is it posible to instal one more SMDB from the existing SMDB and is it practical.
what is a reactive power? what is the relation with power factor?
why would amp draw on neutral wire be as much as amp draw on the hot leg.
given data are load current & power factor cable core size? plz any one update the calculation formula
for 5KW resistive load can anyone please suggest me whether to go for UPS/Inverter or Generator depending upon cost calulations
State Maximum Power Transfer theorem.
Did RMU have ct and pt ?
