Answer Posted / friend
1.6 million approx
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
We select 10mm nominal thickness for Elip head of a pressure vesel. The minimum thickness after forming is 8.2mm. (Shell thickness is 8mm. The minimum thickness after forming is satisfied or not with UG-79 (d)(3) in ASME SECTION VIII, Div.1?
What is the device that converts sound energy into mechanical energy?
how can we find the discharge pressure of the pump with the use of flow and NPSH?
How can I weld A234 WPB and WPB P11 fitting? Any special heat treatment required? What happen if I weld both?
List the energy saving opportunities in air compressor system.
What is the law of thermodynamics?
what is cyclon seperator and water column?
Explain the difference between the flight of a plane and a helicopter?
In convection heat transfer, if heat flux intensity is doubled then temperature
What type of pump use in boiler F.O. system?
"What is fuel oil viscosity, specific gravity?"
State newton’s law of convection.
please provide me the calculation for the thickness of duplex stainless steel pipeline thickness used in process industry ( Water). The details are given below. Diameter : 3" and 4" Thickness : 3.91mm, SCH40 Operating pressure : 62 bar Operating Temp : 35 degree ASME31.3
how can i replace annular plats in tanks
What are SAE ratings?
