Interested to Buy Any Domain ? << Click Here >> for more details...
Why water is not directly added to sulphuric acid for
dilution?
- 8 Answers
- 24994 Views
- I also Faced
- E-Mail Answers
Answer Posted / murthy
if water is added directly into large amount of H2so4, due
to heat of misibility water is vaporized, water required to
dilute greatly increases approximately 15-20 times .that is
why H2so4 is added to water and water is not added to h2so4.
| Is This Answer Correct ? | 5 Yes | 6 No |
Post New Answer View All Answers
What is higher heating value and lower heating value? Is it positive or negative?
What are the some common causes of control valve noise?
MY generator water cooler inlet line height - 11 mtr inlet water line height - 7 mtr water come into the line from overhead tank, O/H tank height - 20 mtr the first tapping in the inlet line is 2" line which down to 4 mtr level plateform., second tapping in inlet water line goes to a pump 6" line installed at 4 mtr level plateform, pump capacity 200m3/hr, head- 30 mtr, hp-40. the outlet of pump of 6" water line connected to a header of 6 mtr long of 6" line, on this header the six tapping are connected, 4 nos. 3" line goes to 11 mtr height water cooler the pressure of the line is 0.15 to 0.25 kg/cm2, 2" and 4" pipe line connected to a cooler at 4 mtrlevel plateform. my question is, at 11 mtr height level the quantity of water and flow is not sufficient for my cooler, the temp. of cooler is rises much more. you are requested to suggest the modification of pipe line/ pump for take more water flow and pressure (desired pressure is 1 kg/cm2)
What is the method involved in analyzing powders for composition?
What is the symbol of sodium?
What chemical is used to expand air bags in such a short amount of time?
Can large temperature differences in vaporizers cause operational problems?
What kind of concerns is associated with temperature pinch points in condensers?
What are the design considerations for a piping system for the transfer of slurries?
In a Furnace arch pressure is more than Hearth pressure,then how flue gas travels to stack
What is a quick way to calculate frictional pressure drops in carbon steel pipe?
how does the properties of an element changes by increasing protons and electrons?
Explain the method adopted to minimize shell side pressure drop in a shell?
What steps can be taken to avoid stress corrosion cracking (SCC) in steel vessels used for storing anhydrous ammonia?
Is there any way to repair a valve that is passing leaking internally without taking our process offline?
