Answer Posted / vijay
Scan time is time required for checking i/p,to executive
program and give out put.generally 5msecfor plc
Is This Answer Correct ? | 9 Yes | 8 No |
Post New Answer View All Answers
How does your previous experience relate to the job you are applying for ?
can anyone tell me about the basic concepts to consider before to start a PLC panel wiring
How do bending tubing provide better measurement than using tubing fittings such as elbows?
We are using Rosemount 5400 series Radar Level Transmitters in all types of Sump Applications having oily water hdrocarbon petrochemical nature. What we are facing the problem frequently is that always getting reading frezzed at some value. If we do power recycling , sometimes it is working . then making same freezing problem. If anybody faced before such type of problem and also having solution , Please give the answer.
What are the types of control valves available
What is Erosion in a control valve?
Is it ok, to use non-contact type Radar type LT, on a tank that is half circular from the bottom side? If yes the, isn't the waves gonna bent in other directions?
POSSITIVE PULSE IS APPLIED TO AN INVERTER INPUT.THE TIME FROM THE LEADING EDGE OF THE INPUT TO THE LEADING EDGE OF THE OUTPUT IS 10 ns. THE TIME FROM THE TRAILING EDGE OF THE INPUT TO THE TRYLING EDGE OF THE OUTPUT IS 8 ns. WHAT ARE THE VALUES OF tPLH and tPHL?
Why upper weighing limit of electronics balance is 90% of the total weighing capacity?
what are the selections available in configuring a burnout protection of a controller? thanks
I m appointed as an automation trainee engineer in small firm in that I am only the one , my company give me a project on s7-200 as i m beginner I don't know how to program so please send me the helpful site so that I complete my project before deadline....please help me out in this critical situation.
Which type of pressure can be measured by primary elements?
What is super thermocoupal?
Why flow/pressure transmitter before control valve?
you must show the examples application and give at least 4 types of transducer/sensors that can minimize the failure during the manufacturing of the resistors.