To check the earth condition (In plug points); the voltage
between earth and Neutral is in below 5 volts. Is it
correct
- 6 Answers
- 7061 Views
- I also Faced
- E-Mail Answers
Answer Posted / anil bhatia
the earth condition depend upon soil condition ,
automosphere condition ,life of earth pit and regularty of
filling water in earh pit chamber.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
what is the formula to calculate voltage drop/loss on 66KV Transmission Line?
What is the difference between PS & metering CT (5p20,0.5 etc.)? Why in PS class CT only Vk is given ? Is PS class CT is more accurate than metering CT?
why steady state stability limit is greater than transient stability limit ? How it can be explained ?
Is it possible to protect 3phase overload and earth fault of the 3phase system using two CT's.
What is the basis for framing the rules of block diagram reduction technique?
Difference between shunt, PMG and AREP excitation. Which is the most reliable between PMG and AREP.
what is the generator rating for 40 amp load of 3phase motor.?? 400v voltage of generator... plz tell me with formula its urgent...plzzz... and also tell me that this 40 amp at all phases mean 40 amp on red,40 amp on yellow,40 amp on blue...... or the total sum of that 3phase is 40 amp....
How to set a Zone 1 distance relay for distribution feeder?
how to handle 2500 kva transformar
What conditions are required for transformer to operate at low frequencies ?
how to calculate distance between busbar supporters for LT panel, what are the factors influencing in this design
WHAT IS SPEC OF CLEANROOM MOTOR AND LIGHT FITTINGS?
What is the most essential condition for the voltage build up for a d.c. Shunt generator?
How to calculate the sag of OPGW during stringing???
what is meant by CT`s saturation ? Can we use Metering CT`s with Protetection CT`s ?
