Answer Posted / james
its not a joke.FF is the exact answer for 11 multiples but
we can also get different voltages by tappings in the
transformer secondary.
| Is This Answer Correct ? | 9 Yes | 18 No |
Post New Answer View All Answers
why we r not earthed Control cable of C.T. terminals
If Polarization index of motor 8.75 at 500volts of medium voltage 4.16 KV motor what this mean winding good or bad pl answer if any reffrence book give me the link
CBCT selection
i want to put single phase load on scott connected transformer,eventhough how to balance the transformer.
what is earthing transformer? draw the winding dia.of earthing transformer.
Explain what cmos is and its benefits?
What is mean by Sensitive Earth fault & what are the effects
What is Control & Relay Panel? And Remote Control Center?
i need project topics along with circuit diagram in the electrical and electronics engg and also some websites regarding projets.
What do you mean by Stimulastion Test in Diesel Genarator / Why & when it's conducted ?
We have Diesel generator of 200KW. fuel consumption is always same,even connected light load or full load. Is it right?
Consider three heater bank connected in 3 phase star with neutral.Each heater bank connected in each phase.So each phase get 230 volts supply.my question is,during balance condition, current flow in neutral or Not
Please, if 1kw is equal to 1.25kva; how then do I know how many kva in 7.5kw?
WHAT SHOULD BE THE BEST CURRENT RATINGS (PRIMARY / SECONDARY)FOR A CT INSTALLED AT THE INCOMING 11KV PANE? WILL IT BE CALCULATED ON THE BASES OF MAXIMUM DEMANT VALUE OR ON SUM OF ALL TRANSFORMER'S KVA? NOMALLY MAX DEMAND REPRESENT THE MAXIMUM OPERATING LOAD OF THE PLANT AND TOTAL KVA OF (SAY 5 NUMBERS TRANSFORMERS) REPRESENT THE CONNECTED LOAD. WHICH i.e. MAX DEMAND KVA OR CONNECTED KVA ARE BETTER TO USE FOR CT CURRENT CALCULATION? PLEASE ANSWER.
Why the moulded plug comes with domestic appliances instead of assembled plug like anchor, Vinay 5/15 A.
