1.How to calculate backup time from series connected battery
of 12v dc with 26Ah for 2battery?
- 3 Answers
- 8999 Views
- I also Faced
- E-Mail Answers
Answer Posted / monojit dutta
IF A LOAD IS CONNECTED WHICH WILL DRAW 26 A AT 24 v (i.e
the load value is 24/26=0.92 ohm), THEN THE BACK UP TIME
WILL BE 1 HRS.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
what maximum range of star & delta in hp or kw ?
for a 400kv t/m line with 10 ampere current will corona occur?
This is urgent!! What is a Thyristor-based 3-ways selector switch with Zero crossing control? how does it operate and where is it mostly found in a system?
I am apply the AAI. So i want electrical sample question paper in technical with answer my id is vijayjobsmart@gmail.com
What is inrush current? how can calculateit? what is the affect of it?
y we use neutral,all r told its used to for closed path..k its a just used to closed path,in a transmission line y we put same conductor used n both phase and neutral..if we use less than phase conductor in neutral mean we ll reduce cost its right r wrong..if we use mean any problem occur in transmission line..
Pls Breifly explain about UPS (Inverter,Reserve,Rectifier,Float voltage,Boost voltage).
what are the advantages and disadvantages of speed control of 3 phase induction motor by varying frequency explain with drawing
im working in one private compeny in gujarat. i was complet diploma electric in 2010 from gujarat technical board. now i want electric supervisor licence in gujarat but i dont't know when i apply? plz give me address of the licence dippartment office in gujarat. gandhinagar
2. Modify your design in question 1.a so that the circuit works according to the following function table X Y F 0 0 Clear 0 1 No Change 1 0 Parallel Loading 1 1 Count 3. Design a circuit that detects the pattern 010 in a serial input X considering: 3.a Overlapping 3.b No overlapping
explain the function of brush less dc motor?
what is the pre charge circuit,what will be work which function it will be use plz tell me
Transmission voltage is kept 11KV,33KV,66KV,132KV,220KV due to form factor. What happen to 400KV and 765KV transmission voltage?
how we calculate electrical load on a building according to area?
Why Ac Systems Are Preferred Over Dc Systems?
