What is latent heat of melting?
What is latent heat of vaporization?
What is difference b/w steam, wet steam, saturated steam
and superheated steam?
What is relationship of boiling point and pressure?
What is mean by HP steam?
What is function of HP steam system?
What are main components of HP steam system?
What is function of steam strainer?
What are conditions for opening of warm up control v/v
LBA10AA050?
What are conditions for opening of turbine control v/v?
- 2 Answers
- 5080 Views
- I also Faced
- E-Mail Answers
Answer Posted / jayaa
latent heat is the heat released or absorbed during the
phase transformation. wet steam is mixture of liquid &
vapour. sat.steam is steam at sat temp. super heated steam
is steam heated above sat. temp.
pressure is directly praportional to the temp.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
How to report calorific values of fuel?
Which material amoung EN8 and EN24 should be selected for the designing of the shafts of rotary kilns
What are the different theories of failure under static load, explain ?
What is the purpose of air blow?
What is the critical speed. Compare the critical speed of hollw shaft and solid shaft.
If 320 grade Gear oil is used in a reduction gear box,what can be themaximum operating temperature of the gear box?
What safety device will activate to stop the compressor in the refrigeration system
tell me about a time when u had too many things to do and u were required opinion prioritized your talks
how can I calculate daya of pump
where i can get APPSC AEE(Mechanical Engg) previuos question papaers
What is the critical temperature of a refrigerant ?
My vendor filled liquid oxygen in our 11000 liter capacity tank. He filled from 1400 MMWC up to 3200 MMWC. I followed the provided conversion table and found that we had been supplied 1800 MMWC liquid which is going to yield 2815 cubic meter. On the other hand, the vendor claims that he supplied as follows:- 5236 cub mtr(3200 MMWC)-2124 cub mtr(1400MMWC) = 3112 cub mtr. I fear that he wants to charge 297 cubic meters extra. He claims that my method was wrong and his was right. He says that this disparity is because of the conical shape of the base of the flask. I will be thankful if somebody can explain me the truth.
current rating of a 3 phase dg set is 20 amp, but what will be the per phase current for single phase supply?
Why is over-pressurizing an air conditioning system bad?
how to change numbering in SAP script i.e. i have 1245.00 now i want to specify in word in script i.e. one thoushand and fourty five rupees.
