Answer Posted / mohamed isam hamwi
synchronising mean connecting additional power source to
existing power supply source on the suitable moment taking
into consideration the following items at the time of
connection :
same voltage value
same frequency
same angle between V&I for both and direction also
in the mean time this usually happened automatically by the
syncronising panel which have this facility to define the
exact second of all these parameter equality
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what will be project cost for 100 kv transformer connection under oyt scheme.
A logic circuit that provides a HIGH output if one input or the other input, but not both, is HIGH, is a(n)?
There is any especial requirement for motor to drive through with VFD?
Define sensitivity?
How DC earth leakage currents can be reduced ?
What is meant by coupling capacitor?
why to use freewheeling diode ( diode in revers bias mode) across dc coil
what is the transmission loss for electrical supply? specifically a large shopping complex where the grid is half KM away, what will the % of transmission loss? is there any transmission loss for captive unit generation for above set? thanks
how the inner and outer body is separated in aircrafts?
Why does the radius of armature is less than the radius of pole shoe?
What is the minimum value of hfe for the oscillations in transistorized rc phase shift oscillator?
Is there any guideline say about display of earthing value near to earth pit
what is spadar bar .why I use in DC generator.
In siemens S7-300 PLC, what is function and function block ? What is the difference between them ? When to use function and when to use function block ?
Why use the vcb at high transmission system ? Why can’t use acb?
