what is difference between 1/2"NPT & M20 x 1.5 cable gland?
Answer Posted / sam
1/2" NPT and M20x1.5 Both are different thread standard,
NPT (Nominal Pitch Thread) is British standard and the
other one is Matric standard. But here for cable gland
1/2"NPT and M20x1.5 (20 mm Dia. with 1.5 mm pitch) should
be similar.
Is This Answer Correct ? | 26 Yes | 39 No |
Post New Answer View All Answers
find the kp ki kd from the transper function G(S)=29.44s+04707/1.5349s2+s
what is the advantage of submersible level transmitter compare to ultrasonic level transmitter?
Define the difference between a stable versus an unstable controlled system and some of the tools you might use to be able to detect when this is happening and assumptions used for control system application design that could contribute to instability
Speedtronic system .
In Safe Guarding test what means by "Failed to Danger" ?
Which Signal hart communicator work? If there any signal change when hart connect while transmitter in line ?
how to measure oxygen which methods are using?
How to Calibrate Interface Level Troll in field
We are using Rosemount 5400 series Radar Level Transmitters in all types of Sump Applications having oily water hdrocarbon petrochemical nature. What we are facing the problem frequently is that always getting reading frezzed at some value. If we do power recycling , sometimes it is working . then making same freezing problem. If anybody faced before such type of problem and also having solution , Please give the answer.
What is instrumentation control?
can anyone can let me know in Eurotron Micro cal 2+ calibrator in milli amps source mode we are not able to get 20 milli amps output it only produces 1.52 milli amps out, but display shows increase in milli amps , and err6 displays, let me know how to remove the err 6.
WHY THE DEGREE OF VALVE PLUG AND VALVE SEAT IS SLIGTLY DIFFERENT I CONTROL VALVE TRIM DESIGN
we have level transmitter for h2s04 storage tank capacity 10k ,always there are failure of transmitter due to failure of magnetic floats ,please come up with solutions at the earliest.
in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.
State some of balance principle’ advantages?