Answer Posted / venkatesh vaidya
DC is the best source of power supply. Because we can store
the DC power in batteries, where as AC cannot be stored.
But for human safety purpose and universality AC has became
most economical way of production and consumption. Also in
case of power losses and harmonics DC holds up wrt to AC.
Generation of AC is quit simple wrt to DC, because
commutator and brushes are required in case of DC
production. AC is consumed as it is produced, ie; use it or
loose it. DC is exemption for this. there are many way by
which DC can be produced with out emitting CO2 to
environment, such as chemically, solar, etc. eventhough
there are some ways to produce AC ecofriendly, but there is
dispute of economy.
Is This Answer Correct ? | 11 Yes | 0 No |
Post New Answer View All Answers
In a voltage-controlled current source A A current booster is never used B The load is always floated C A stiff current source drives the load D The load current equals Isc
can u give me a brief idea about power line carrier communication ??
how to get bearing & winding temperature of an induction motor?
what is cause of static electricity? I experience shock when i touch metal equipment in a room ,furher check shows earth leakage showing 80ma at the DB near to the 400 MCCB?
What is lc oscillator?
Define the overload capacity of the motor?
What si the d/f b/w KVA & KWH, kvarh & kvar, kwh & kvar phase voltage & line voltage
What will be the impact on motor performance if a LT motor is rewound with changed motor winding data as given below:- Original winding data: total 04 wires = 02 wires of 17 SWG + 02 wires of 16.5 SWG. Changed Winding data: total 03 wires of 15.5 SWG wire size Motor rating: 160KW, 740RPM, 415V, ID FAN application. Normal Running Current = 95% of FL Current.
What Is Connection APFC Panel In Compony.
What is the most important precaution in any experiment with d.c. Shunt motor?
During underground cabling in landscape area what did we cover the cable with to prevent the electric shock & protect the cable?
what is the purpose of shading ring or shading coil in electrical equipments.
What is mason's gain formula?
What is a copper loss or i2r loss pc?
What is the difference between solid grounding and impedance grounding?