Interested to Buy Any Domain ? << Click Here >> for more details...
how to select the cable size? any formula to calculate cable
size?
- 4 Answers
- 8720 Views
- I also Faced
- E-Mail Answers
Answer Posted / senthil.m
first calculate the power,power means voltxcurrent,these
voltage means potential differeence,the current means
electrons electrons means (heat) flows throw conductors so
cable inside heat flows, so answer depens upon the
heat,heat inversalypropotional to the coil,
| Is This Answer Correct ? | 0 Yes | 8 No |
Post New Answer View All Answers
What do you understand by avr?
Why sometime AVR and sometime Booster coil is used in Alternator? what is the diferance between AVR & Booster coil due to which they are selected
what is difference between isolation and ultra isolation transformer?, what is the method of testing ?
Is it a better option to procure screw type air compressor rather than reciprocating air compressor?If so, what is the reason?How should we select an air compressor(100 CFM)? Please mention the important parameters of air compressor.
Why is the starting current high in dc motor?
1))why we run three phase or three different circuit from a single conduit 2)) why not two circuit of different phase run in same conduit?? and why we run same three cicuit of same phae run in single conduit??
How o select the electrical fuse?.What are its characteristics.How to select the material od fuse?
what r the safety measures in UPS ? explain all?
I WANT HOW CALCULATE TO CABLE FOR WELDING PLANT ?
Can i use the B-curve MCB instead of C-curve MCB
can we use engine degreaser for electrical motors?
Why are the cores of large transformers built up of circular transactions ?
What is core CT & it's function?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
what is the safe meggar values for motor, transformer HT, LT and Cables? IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace. why we generally use 3.5 core cable or in other word 1/2 core for neutral and also confirm me that in balance conditiob(3 phase)current in neutral will zero
