Answer Posted / sanny prajapati
Pin 33 of 8088 and 8086 IC accepts Minimum and Maximum mode
(MN/MX) signal to select the processors operating mode. Thus,
MN/MX=’1’ initiates minimum mode and MN/MX=’0’ initiates
maximum mode of operation
| Is This Answer Correct ? | 12 Yes | 1 No |
Post New Answer View All Answers
Can i know what will be the cut off criteria for go to final isro interview??
I AM APPERING FOR RRB EXAM FOR SECTION ENGINEER I REQUEST U TO PLZ FORWORD THE PAPER PATTERN AND EVEN PREVIOUS QUESTION PAPER to stamil230@gmail.com
Explain what kind of negative feedback is present in a noninverting op-amp.
Why is base made thin and lightly doped?
in govt polytechnic lecturers tell me what is the expected cut off for ece after the interview list announced
What is meant by operating point?
What is the purpose of using data modem.
Explain why the antenna is called passive element?
why the signals of wireless in db value
also send me aptitude question paper
hai iwant RRB previous 5 years question papers
We are facing the problem of communication failure between seimens drives and ABB DCS. Between drives and DCS on RLM -01 module for communication purpose. We found red blinking i.e error blinking in RLM -o1 module. So we replaced with new one but after one month same problem again came. So again we installed old RLM-01 module. Now also RED blinking is coming but sometimes drives are not tripping. What will be the cause for this problem?
What are the effects of ageing or using second hand IC or other electronic components?
What is a weighted code?
What is a low-pass filter?
