why, when birds sit on transmission lines or current wires
doesn't get shock?
- 36 Answers
- 49486 Views
- College School Exams Tests, Infosys, I also Faced
- E-Mail Answers
Answer Posted / yogesh
the bird doesn't get shock because we know current flows
only through a closed circuit with low impedence now due to
presence of high impedence because of absence of any
conductor between bird and ground the current can't have any
connection with ground and hence closed ckt or closed path
can't be established between bird wire and ground hence the
bird doesn't get shock.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is the formula for selecting the cabels according to load? How to calculate what sq.mm cabel to be used?
Why the cores of large transformers build up of circular cross section?
why Y CONNECTION IS BETTER INTERMS OF EFFICIENCY AND P.F FOR A LAOD LESS THAN 40% AND WHY AFTER DELTA IS BETTER FOR > 40%
What is cable tray, its type, and its support?
what is the isolation transformer. what is the isolator?
Why the earth to phase voltage is high 250 compare to other two phases
If we have to feed a housing complex having load 8MVA, than what would be the better option, either we first step down 33kv supply into 11kv & than 430v or we proposed no of 33/.44 kv transformer, also which option is economical?
Why the moulded plug comes with domestic appliances instead of assembled plug like anchor, Vinay 5/15 A.
What is knee point voltage?
A system absorbs 100 k J of heat and the increase in its internal energy is 100 kJ; the work done is
what is the relation between size of the anteena and wavelenghth of radiated wave
if there is nutral in phase why we use earthing wire and grounding? even at fault condition the fault current flows to neutral (it is a lower path)
what is meaning of sympathetic tripping with respect to relays and give the values for current carrying capacities for copper and aluminium cables from 16sq mm to 500sq mm
how can i find ct ratio of meter by seeing name plate of meter and how it should be used in MF calculation if it shows only-/1???
please describe the Transformer setting, Motor setting, I/C setting, Tie setting
